Description
- Support up to G.fast with 900Mbps aggregated line rate as well as fallback to VDSL2/ADSL2+ support, or alternatively may use SFP or Gigabit Ethernet as WAN interface
(* measured throughput at short loop) - Integrated Ethernet switch with automatic speed-sensing and crossover correction, which serves one Gigabit Ethernet and three Fast Ethernet ports
- Concurrent IEEE 802.11b/g/n 2Tx2R and 802.11ac 3Tx3R wireless LAN supports up to 1,600 Mbps link rate that delivers excellent performance while air transmission is secured by either 802.1X, WEP, WPA or WPA2
- USB host ports support specific plug-and-play functionalities
- Support two FXS/POTS ports with abundant SIP VoIP services
- Support networking protocols such as PPP, NAT, Routing, DHCP server/relay/client and IPv6 Configuration and management by Web-browser through the Ethernet interface and remotely through DSL interface, and firmware is upgradeable through HTTP or TFTP
- Support TR-064, TR-069 or SNMP for local/remote managemen
HARDWARE
WAN Interfaces
- One 2-wire loop with 100 ohms line impedance in RJ-11 connector
- Fully compliant with the ITU-T G.fast Recommendations
(G.9700&G.9701) and supports 106a profile - Supports ITU-T G.994.1 G.hs, and ITU-T G.9971 with future extensions for G.fast as well as ITU-T G.997.2
- Compliant with G.992.1 annex A, G.992.2 annex A, G.992.3 (ADSL2) Annex A, B, Land M. G.992.5 (ADSL2+)Annex A, B and M, ANSI T1.413, G.994 and 1.432 ATM physical layer
- Alternatively via MSA compliant SFP slot
- Alternatively via 10/100/1000Base-T Gigabit Ethernet WAN port in RJ-45 connector, comply with IEEE 802.3/802.3ul 802.3ab
- AC to DC adapter: input 100-240 WAC 50 or 60 Hz; output 12 VDC 2.5 Amp
- Dimensions (W x D x H) 235 mm x 163 mm x 41 mm
Local Interfaces
- Four 10/100/1000Base-T Ethernet ports in RJ-45 connector, comply With IEEE 802.3 standards
– 802.3az Green Ethernet - Integrated IEEE 802.11n compliant, 2Tx2R (a) 2.4GHz wireless LAN access point, backward compatible with 802.11b/g
– Optionally IEEE 802.11ac compliant, 3Tx3R a 5GHz wireless LAN access point, backward compatible with 802.11a/n
– Two internal 3dBi antennas for 2.4GHz, and three for 5 GHz – RF radiated power is up to maximum 100mW EIRP - Two USB 3.0″ host ports in type A connector, each with up to 500mA/ 5Voic power supply (* may change to USB 2.0)
- Two FXS/POTSports with RJ-11 connector to connect to traditional telephone set
- WPS/Wi-Fi On-Off button: short click to enable disable wireless LAN; long push to start the WPS (Wi-Fi Protected Setup) process
ATM
- AAL0, AAL5, OAM, RM and Transparent cell types
- Traffic shaper/scheduler: priority scheduling;per-VCC queuing: UBR/CBRIVBR shaping based on Peak Cell Rate (PCR), Sustained Cell Rate(SCR), and Maximum Burst Tolerance; Minimum Cell Rate Shaping; Multi-priority AAL Queuing
Routing
- RFC2684 / RFC 1483 bridged and routed PDU encapsulations
- MAC Encapsulated Routing (MER)
- Support Point-to-Point Protocol (including PPPoA and PPPoE) and user authentication Via PAP CHAP or MS-CHAP
Wireless
- Hidden SSID to secure own WLAN; up to four SSID’s support for virtual AP of Guest network
- Network authentication supports open, shared, WPA, WPAPSK, WPA2, WPA2-PSK, mixed WPA, WPA2 or WPA-/WPA2-PSK
Bridging
- RFC2684 / RFC1483 bridged PDU encapsulation
- Transparent bridging (IEEE 802.1D) with at least 32 MAC addresses
NAT and Firewall
- NAT: Up to 512 translations with 16 static entries, virtual server up to 20 entries, DMZ and extensive ALGs
USB Host
- •Supports mass storage device and Samba for file sharing inside local network
VolP and Telephony Bonus Services
- Supports SIP (RFC3261), SDP (RFC2327, RFC3264) as well as both TCP and UDP transport
- Supports User Agent Client (UAC) – User Agent Server (UAS)call, or proxy call routing
- Supports SIP and telephone URL addressing
- Supports in-band DTMF tone sending 1 receiving and outband DTMF signaling with RTP, as per RFC2833
Reviews
There are no reviews yet.